I'm trying to calibrate my PT2 pedals. On the calibration screen without touching any of the pedals there showing some input already. After full press of all pedals they are not showing as pressed all the way. When in a car brakes and throttle is applied without touching pedals.I tried several times with same results. There are some adjustment on the pedals themselves that may fix this, however if it does fix it then all other sims will be un-calibrated will have to readjust them all. Anyway to properly calibrate these in the game itself?
Same issue here! I'm using Fanatec DD2 for the wheel, selected seperate pedals, can bind throttle/brake to my HPP pedals but then having the same issues you describe above, making it not playable at the moment.
Mee too with Fanatec DD2 and HPP 3PRX SE it's a shame....... Tgis is what happen when u use a graphic engine of project cars 2........ Dear Reiza this is not a good start.......
It's possible that re-calibrating the pedals using DI-View will help to clean-up the signal. If the signal is active too close to the travel-limits, it can be unstable. You want to allow a little margin (set high / low limits) so the signal doesn't jump around. Although it's less likely, another thing to consider may be EMI with some hardware configurations. HE-pedals often come with an optional ground-wire to address it when its suspect. Of course, that's not to say there could be no calibration issue with the game.
RESOLVED with DIVIEW calibration software. Thanks Ps now I can run the game let me say that vr is not so good.... inside car detail ok but outside is poor...
you didn't you didn't edit your signature in your profile. So nobody knows your specs. Did you try to edit the sharpness settings in the graphicsconfigfile ?
I can't get mine to work, the HPP pedals say positive, I calibrated them with DIVIEW but still the pedals will not work. Anything else I can try?
