1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can't play with spring mods

Discussion in 'Automobilista - Help & Support' started by LoT, Dec 16, 2018.

  1. LoT

    LoT New Member

    Joined:
    Dec 16, 2018
    Messages:
    8
    Likes Received:
    4
    Hello,
    I have got the Thrustmaster T3PA Pro pedal set and I upgraded both my brake and throttle with a stronger spring. I tried to calibrate my pedals but there didn't seem to be an option.
    I googled it and I've read there's no that can be done about it.
    So, in a last resort this post.
    I also got the Thrustmaster TS-PC racer and I couldn't configure my buttons.
    I'm hoping there's a solution for both these issues as I'm looking forward to all the tracks in the game I've never raced before.

    Greetings,
    Nico
     
  2. Dave Stephenson

    Dave Stephenson Administrator Staff Member

    Joined:
    Feb 13, 2016
    Messages:
    277
    Likes Received:
    210
    Deadzone and sensitivity can be modified on the axis tab of the controls screen.
     
  3. LoT

    LoT New Member

    Joined:
    Dec 16, 2018
    Messages:
    8
    Likes Received:
    4
    Thx, however after 0% deadzone and 100 sensitivity there's still a couple % of the throttle bar that is not being filled.
    I tested a couple of cars, I'm not sure if it affects me but I think it does.
     
  4. heideracer

    heideracer New Member

    Joined:
    Mar 9, 2016
    Messages:
    9
    Likes Received:
    0
    Don't push the pedals while booting the computer. the wheel will do an autocalibrate. After login go to the windows controller setup for your wheel and look for the bars for clutch , brake and throttle. NOW push the pedals to their max. Any better now?
    To force a calibration while in windows pull and replug the power plug on the wheel.
    I hope this helps
     
  5. jose46lopez

    jose46lopez Active Member

    Joined:
    Sep 30, 2016
    Messages:
    101
    Likes Received:
    28
    Hi, maybe a little program called dxtweak2 will help you. You can find it easily.
     
    • Agree Agree x 1
  6. Dave Stephenson

    Dave Stephenson Administrator Staff Member

    Joined:
    Feb 13, 2016
    Messages:
    277
    Likes Received:
    210
    @heideracer I think in this instance the mod may physically prevent reaching 100% depression so shortening the axis is probably the only way.

    @jose46lopez good shout, that should do it for sure.
     
    • Like Like x 1
  7. LoT

    LoT New Member

    Joined:
    Dec 16, 2018
    Messages:
    8
    Likes Received:
    4
    That did the job.
    Thank you so much for the help!!
     
    • Like Like x 3

Share This Page