Bug Reports - Automobilista 2 (Read the Opening Post)

Discussion in 'Automobilista 2 - General Discussion' started by Heitor Facuri Cicoti, Apr 4, 2020.

  1. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    .. following on.. Engine information I have been able to gather for Copa Truck.

    IVECO (Stralis) 12.9 L - Cursor 13 - Straight 6
    MAN (TGX) 12.4 L - D2666 - Straight 6
    Mercedes-Benz (Actros 2651) 12.8 L - Euro V1 - Straight 6
    VW (Constellation) 9.4 L - NGD 370 - Straight 6
     
    Last edited: Apr 6, 2021
  2. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Track: Bathurst
    Report: Nothing major. Hell Corner runoff is a little short as there is a invisible wall.

     
    Last edited: Apr 6, 2021
  3. oez

    oez Mayor of Long Beach AMS2 Club Member

    Joined:
    Aug 27, 2020
    Messages:
    697
    Likes Received:
    680
    Track & Layout Used: Silverstone 75, no chicane
    Car Used: F-Vintage Gen 2 Lotus
    Version: 1.1.3.5
    Applicable Settings: irrelevant
    Report: Engine sound doesn’t go beyond rev limit when over-revved. High over-revving caused car to stop instantly and start vibrating. RPM gauge and rear tire telemetry went crazy.
    Steps to reproduce: Drive the car in test day and over-rev it on purpose. Go from 3rd gear max revs to 1st.
     
  4. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Car: Copa Classic Gol FL
    Report: This vehicle is not turbo charged and the boost adjustment does nothing. Please remove.

    ams2_gol_fl_setup_bug.jpg
     
    • Agree Agree x 1
  5. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Class: Copa Classic RS B & FL
    Report: Firstly I could be wrong as maybe a vehicle runs over the minimum weight however they are aligned with another weight class and it looks like a couple of the vehicles minimum weight is out compared to the 2018 (and 2015) Copa Classic RS technical regulations. The regs also state that ballast is used as these cars are bare body shells.

    It looks to me like the Fusca FL (AP) should be in the 880 KG class a long with the Passat's...

    Maybe the Ui is just out.. Or maybe not..

    ams2_copa_classic_rs_weight.jpg
    ams2_copa_classic_rs_weight_regs.jpg
     
    Last edited: Apr 7, 2021
  6. MCor57

    MCor57 Active Member

    Joined:
    Aug 15, 2020
    Messages:
    137
    Likes Received:
    165
    also from me the same problem of the grass
     
  7. deadly

    deadly Well-Known Member

    Joined:
    Jul 8, 2016
    Messages:
    1,513
    Likes Received:
    532
    Version: 1.1.3.5
    Track: Hockenheim 1988
    Report: The tyre barrier in "Ostkurve" (2nd chicane) is like a concrete wall. Because of their rude driving style, AI have always crashes there in lap 1, followed by a huge pile up for a long time.
     
  8. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Vehicle: Copa Fusca
    Report: The 3D model and the engine info is out for the Copa Fusca. This class/vehicle features a liquid cooled 1.6 L inline 4 cylinder AR engine which is why you have the hood cut outs correctly modeled however the extra rear engine bulge is not present. You do however have this modeled correctly in the big sister 1.8/2.0 L Fusca FL..

    All modern Copa Fusca's RS feature the rear bulge. See here: Copa Fusca RS

    ams2_copa_fusca_ui_bug.jpg
    VS

    ams2_copa_fusca_ui_bug_2.jpg


    See 1:06 mark



    ams2_copa_fusca_ui_bug_3.jpg


    rear engine bulge in bodywork
    [​IMG] [​IMG]

    inline 4
    [​IMG]
     
    Last edited: Apr 9, 2021
    • Informative Informative x 1
  9. ZakMcKracken

    ZakMcKracken New Member

    Joined:
    Apr 8, 2021
    Messages:
    27
    Likes Received:
    1
    Track & Layout Used: Hockenheim 1988 short
    Car Used: Mercedes Benz Evo DTM / any
    Applicable Settings: -
    Report:

    This is an addition to rmagid1010 report:
    Corner 2 and 3 inner curbs have no collision mesh, car momentarily falls through track and violently re enters track (AI is mostly launched into air):
    vlcsnap-2021-04-08-19h18m54s910.png vlcsnap-2021-04-08-19h19m10s854.png vlcsnap-2021-04-08-19h19m51s617.png vlcsnap-2021-04-08-19h20m21s167.png vlcsnap-2021-04-08-19h21m28s623.png
    Also a piece of tarmac between corner 2 and 3 that is not part of the track will let cars just fall out into the void:
    vlcsnap-2021-04-08-19h19m28s488.png vlcsnap-2021-04-08-19h19m31s618.png

    slowly approaching meshes / race snippet

    UPDATE:
    Tarmac on right hand side just before corner 3 also has no collision mesh:
    vlcsnap-2021-04-18-06h48m49s469.png vlcsnap-2021-04-18-06h48m53s794.png

    Steps to reproduce: Drive over curbs in corner 2 and 3 or over tarmac strip on the right side between these corners / drive over tarmac strips on right hand side between grass patches
     
    Last edited: Apr 18, 2021
    • Like Like x 1
    • Funny Funny x 1
  10. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Vehicle: Copa Classic FL Fusca
    Report: Should be listed as RWD not FWD...

    ams2_copa_classic_fl_fuscu_ui_bug.jpg
     
  11. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Vehicle: Hot Car Fusca (1983-1987)
    Report: Vehicle uses a air cooled 1600 VW and should be listed as RWD not FWD and furthermore the wrong 3D has been used as the rear engine bulge is not needed as this for the modern inline 4 cylinder version found in Copa Fusca & Copa Classic FL. Your modern Copa Fusca & classic Hot Car Fusca rear end body detail could be swapped around if you wanted too..

    ams2_hc_fusca_ui_bug.jpg
     
    Last edited: Apr 9, 2021
  12. I Drive Demons

    I Drive Demons Member

    Joined:
    Mar 2, 2021
    Messages:
    76
    Likes Received:
    20
    So I am not sure if this is a bug, this is 95 percent difficulty and 40% aggression. The AI seems to be doing the cooldown pace. This is also coming off as having some AI issues that I am still confirming. But I do not think that at 95% I should be able to get a 1 minute lead. My driving is far from perfect too.

     
  13. MCor57

    MCor57 Active Member

    Joined:
    Aug 15, 2020
    Messages:
    137
    Likes Received:
    165
    Track & Layout Used: Any
    Car Used: McLaren M23
    Report: When you look back, you notice that the air intake is cut in half
    20210408174546_1.jpg


    Track & Layout Used
    :
    Imola 2020
    Report: The ambulance is located within the walls of the box
    20210228222632_1.jpg
     
    • Funny Funny x 1
  14. MCor57

    MCor57 Active Member

    Joined:
    Aug 15, 2020
    Messages:
    137
    Likes Received:
    165
    Track & Layout Used: Any
    Car Used: Camaro SS (Street)
    Report: rear view 20210408173445_1.jpg
     
  15. MCor57

    MCor57 Active Member

    Joined:
    Aug 15, 2020
    Messages:
    137
    Likes Received:
    165
    Car Used: Formula Reiza
    Report: radio cut into several parts
    20210407162342_1.jpg 20210407162629_1.jpg
     
  16. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Please add Opala Old Stock to the list..
     
    Last edited: Apr 9, 2021
  17. Micropitt

    Micropitt Mediocre driver doing mediocre laps AMS2 Club Member

    Joined:
    Jun 16, 2020
    Messages:
    728
    Likes Received:
    544
    Version: 1.1.3.5
    Track & Layout Used: Tested on Nordschleife
    Car Used: Sigma P1
    Applicable Settings: Test Environment,
    Report: Excessive engine wear, at default settings (Boost Pressure 80%) engine will last 2 laps even with careful gear change, setting Boost Pressure to 0% makes the engine wear slow down but also takes away a good amount of engine power. (Tested by @Shriukan )
    Steps to reproduce: Test on the Nordschleife
     
    • Agree Agree x 1
  18. Shriukan

    Shriukan Touristenfahrten Community AMS2 Club Member

    Joined:
    Sep 23, 2019
    Messages:
    1,293
    Likes Received:
    931
    Just to add, even at 50% boost, the engine damage/wear is about 1%/min. These machines are supposed to do 4h races or more.
     
    • Agree Agree x 1
  19. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Version: 1.1.3.5
    Vehicle: MCR S2000
    Report: I am not sure if this a bug or not however I have seen something a little odd with this race car that I have not seen before. The wheel spin LED's on my Fanatec V2 Formula rim are permanently lit up and on some tracks, ie. Cascavel there is continuous (what feels to be) subtle scrub vibration coming through grip motors of wheel rim. On the back straight of Cascavel this is very evident and the LED's are permanently lit up around the whole lap. The Metalmoro MRX does not behave like this.
     
    Last edited: Apr 10, 2021
  20. Haris1977

    Haris1977 Active Member

    Joined:
    Apr 7, 2020
    Messages:
    395
    Likes Received:
    105
    Track & Layout Used: all
    Car Used: BMW M3 car (Group A)
    Version: 1.1.3.5
    Applicable Settings: irrelevant
    Report: Not a bug, but a camera issue. In dash cam should be placed a little to the right (in order for the red line to be in line with the green line)

    IMG_2441.JPG
     
    • Agree Agree x 1

Share This Page