Bug Reports - Automobilista 2 (Read the Opening Post)

Discussion in 'Automobilista 2 - General Discussion' started by Heitor Facuri Cicoti, Apr 4, 2020.

  1. ozcanuck

    ozcanuck Active Member

    Joined:
    Apr 13, 2016
    Messages:
    191
    Likes Received:
    162
    Had the same with Stock Car 2020 at Velo Citta...endless cool down lap...no way to quit.
     
  2. F1Aussie

    F1Aussie Well-Known Member AMS2 Club Member

    Joined:
    Mar 21, 2016
    Messages:
    2,405
    Likes Received:
    663
    A similar thing happens at Interlagos if you go straight on at end of pit straight, then turn left into barrier you go under it and into cyberspace.
     
    • Funny Funny x 1
  3. ahpigsy

    ahpigsy Member

    Joined:
    Apr 2, 2020
    Messages:
    30
    Likes Received:
    21
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Goiania External
    Car Used: Stock Car & Stock Car 2020
    Applicable Settings: Nowhere to change AI strength
    Report: Championship Season AI 10 seconds off the pace.

    First of all the game takes you straight into Qualifying, their is no practise.
    Then once in practise the AI is some 10 seconds off the pace. There is nowhere to change the AI strength as far as I can see. I have AI strength set to 100 in custom race, but it doesn't seem to pick that setting up.
     
    • Agree Agree x 1
  4. TekNeil

    TekNeil Take me back to the 2.4l, twin 50 weber days...

    Joined:
    Mar 9, 2020
    Messages:
    412
    Likes Received:
    229
    Track & Layout Used: N/A
    Car Used: N/A
    Applicable Settings: N/A
    Report: With logitech G29/pedals, still have to calibrate the brake pedal twice in a row to stop it being overly sensitive.
     
    • Like Like x 1
  5. Damian Baldi

    Damian Baldi Active Member

    Joined:
    May 28, 2020
    Messages:
    180
    Likes Received:
    131
    Track & Layout Used: Kyalami 72
    Car Used: Brabham BT44
    Applicable Settings: Driving on the rain
    Report: It looks like there is a mix of wet tires and slick tires. My car shows a modern wet tire, while the car in front was with a vintage rain tire or maybe it's a pre-slick tire. Meanwhile, a friend driving another Brabham BT44 see that my car is on slick tires while it's with rain tires and viceversa.


    20200702003539_1.jpg


    This is how wet tires of that period looks like
    unnamed.jpg
     
    • Agree Agree x 1
    • Informative Informative x 1
  6. laurent34

    laurent34 New Member

    Joined:
    Jul 2, 2020
    Messages:
    2
    Likes Received:
    0
    New
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Any
    Car Used: Ginetta GT4 or Sprint
    Applicable Settings: Any
    Report:
    On Fanatec CSP V3 + CSL Elite base, latest firmware
    Brakes randomly activates, I can see braking light blink for like half a second/a full second
    It's random, not a regular pace or permanent braking
    Calibration is ok, there is no "noise" in braking input in UI or fanatec drivers UI, but ingame there is random braking input

    Steps to reproduce: Any session
     
    • Agree Agree x 1
  7. AndreiC

    AndreiC Active Member AMS2 Club Member

    Joined:
    Apr 3, 2019
    Messages:
    742
    Likes Received:
    186
    "Lower your shadow details. We don't even know what GPU or CPU you have... Add this info to your signature."
    Intel I5 4690k, Radeon RX 590 8Gb ram, 16Gb Ram DDR3


    So I lowered my Shadow detail from Ultra to Low but doesn't help :
    Imola Shadows Low :


    To compare Spielberg with the same settings has not fps problems :


    "What are your FX settings?"
    I attached a printscreen

    "Are you running other software in the background?"
    Only Fraps to display fps and Radeonlive records video

    "Are you drivers updated?"
    All drivers are up to date.

    "How many cars are you racing against? Online or Single player race?[/QUOTE]"
    Single player and in all videos 15 AI.

    EDIT 1: I disabled FX, doesn't help
    EDIT 2 : Tried reducing MSAA to LOW, didn't help
     

    Attached Files:

    • rei.jpg
      rei.jpg
      File size:
      320.7 KB
      Views:
      261
    Last edited: Jul 2, 2020
  8. VFX Pro

    VFX Pro Well-Known Member AMS2 Club Member

    Joined:
    Mar 31, 2017
    Messages:
    1,279
    Likes Received:
    697
    Problem #1 - AMS2 and PC2 were optimized for Nvidia GPUs
    Problem #2 - Don't record videos while your playing... that's a way to kill your FPS. Only record if you are doing youtube stuff and record at 1080p not higher. To do you need a REALLY powerful CPU and GPU to do so.
     
  9. AndreiC

    AndreiC Active Member AMS2 Club Member

    Joined:
    Apr 3, 2019
    Messages:
    742
    Likes Received:
    186
    Problem #1 Should not be a problem as long as pcars 2 has no fps problems. I already posted this link in my previous post. Both games having identical settings pcars 2 has 77fps at start and AMS 2 44 and if you watch the video you will see fps in pcars stays very high during the whole lap compared to AMS 2!


    Problem #2 Without recording I still only get 44 fps at start and in the problem sectors seen in the videos. You can see in the printscreen.
     

    Attached Files:

  10. AndreiC

    AndreiC Active Member AMS2 Club Member

    Joined:
    Apr 3, 2019
    Messages:
    742
    Likes Received:
    186
    After more testing this fps drop occurs around the sunset no only after.
     
  11. AndreiC

    AndreiC Active Member AMS2 Club Member

    Joined:
    Apr 3, 2019
    Messages:
    742
    Likes Received:
    186
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Imola
    Car Used: Ultima GTR Race
    Applicable Settings: Weather - Clear
    Report: AI randomly turn their headlights on and off
    Steps to reproduce: Drive after the sunset at 0:00
     
  12. SRS13Rastus

    SRS13Rastus Member AMS2 Club Member

    Joined:
    Apr 12, 2020
    Messages:
    95
    Likes Received:
    90
    Game Version/Build: 1.0.0.1
    Track & Layout Used: Goiania External championship
    Car Used: Stock Car & Stock Car 2020
    Applicable Settings: Car doesn't refuel in pit stop
    Report: Ran qualifying got pole, car fueled with 80 litres ran 32 mins before crew chief advised pitting for fuel, entered pit car sat in position fuel bar remained red repair bar slowly filled yellow (hadn't hit anything in the race nor excessively run over kerbs). exited pits car ran out of fuel immediately after exit.
    Retested by same fuel load as above ran it down to 60 litres requested pitstop, entered pits, same thing but repair took less time than previous try, This leads me to suspect the wrong bar is being filled in the pitstops in championship. Will test single race too and edit if need be.
    Steps to reproduce: Run 5-10 laps in 1st event and then pit whilst monitoring fuel level on entry and exiting the pits.
     
    • Agree Agree x 1
  13. SRS13Rastus

    SRS13Rastus Member AMS2 Club Member

    Joined:
    Apr 12, 2020
    Messages:
    95
    Likes Received:
    90
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Goiania External in Championship
    Car Used: Stock Car & Stock Car 2020
    Applicable Settings: Nowhere to change AI strength
    Report: No ability to adjust AI levels (strength or aggression) 1st try also car selection is greyed out so cannot pick the correct car, enter championship and it will supply you the last car you drove or used.
    **Work around**
    **Go to test day or single race select correct car and set AI levels there, exit out and re-enter Championship you now have the correct car and AI levels are much better.**
    AI was several seconds off my pace 1st try did the workaround above and set AI to 100% strength and aggression AI was then only 1 second off the pace in qualifying, ran the race and encountered my no refuelling bug report above...
    Steps to reproduce: enter championship and see car select greyed out, enter anyway and be supplied last car selected in either test day, time trial or single race. use **work around** above and car is correct and AI levels are changed.
     
    • Agree Agree x 1
  14. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : All
    Car Used: All
    Applicable Settings: All
    Report: This is not a bug. Please consider moving the motion blur option from Performance page to be listed under Visual FX page with all the other post processing effects..
     
  15. Mahjik

    Mahjik Active Member

    Joined:
    Mar 2, 2020
    Messages:
    138
    Likes Received:
    63
    Just FYI, the reason it was put there during the Project CARS days is because it has a heavy impact on performance.
     
    • Agree Agree x 1
    • Informative Informative x 1
  16. Damian Baldi

    Damian Baldi Active Member

    Joined:
    May 28, 2020
    Messages:
    180
    Likes Received:
    131
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : All
    Car Used: All
    Applicable Settings: Multiplayer / Hosting
    Report: There are some bugs/issues with the multiplayer functions. I'll list some I suffered more than one time, and some of my friends too.

    - The most important it's some kind of inherit that occurs while joining a server. Your system inherit all the multiplayer server/hosting configuration. If you have your settings well defined, you will loss all because it inherit the setting of the last server/hosting you joined.

    - If the host of a race leaves the hosting, the rest of the drivers can't pass to the next season, leaving everybody trap in that season, until everybody leaves and the hosting dissapears.

    - Several drivers/users click on "exit" button at the end of a practice season thinking they will go to the pits/garage, because nothing indicates that the season is over and next one is coming. The worst thing about this, is that everybody realizes they have leave and inmediately rejoins, but then qualy season already started and they can't be part, sending all the practice nowhere.

    - If you join a lobby of a hosting or a dedicated server and you leave before loading the track, your steering wheel won't be recognised and won't work at the inmediately next race. You have to restart AMS2 to get the wheel back.
     
    • Agree Agree x 2
  17. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Thanks for the info.. If moved I guess the help tips could be utilized to let the user know this is a heavy hitter. Most of the PP effects have some info however some are missing..
     
  18. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Bathurst
    Car Used: F1 V10
    Applicable Settings: All
    Report: You can still adjust ARB on the fly whilst driving the car. I can't find the change log line that said this was sorted for a range of vehicles..
     
  19. Coanda

    Coanda aahhh whinge whinge f@#ken whinge.. Staff Member AMS2 Club Member

    Joined:
    Apr 8, 2020
    Messages:
    2,142
    Likes Received:
    2,076
    continue.. Alignment is out on the main vehicle selection Ui too.

    StockCar_2020_Ui_class_bug_2.jpg
     
  20. PM123

    PM123 New Member

    Joined:
    Mar 25, 2020
    Messages:
    3
    Likes Received:
    0
    Game Version/Build: 1.0.0.1
    Track & Layout Used
    : Any
    Car Used: F1 V10, F1 V12
    Applicable Settings: All
    Report: No suspension animation

    Changelog v 1.0:

    VEHICLES
    • Added wiper animations and cockpit vibrations for Metalmoro AJR, Sigma P1, Opala (all variantes)
    • Added DRS wing animation for F-Ultimate, F-Reiza, Sigma P1, AJR Chevy & Honda Turbo
    • Added suspension animation for F-Ultimate, F-Reiza, F-V10, F-V12, F-Vee
     

Share This Page