At my wits end! I have an Logitech RS50 that I cannot get calibrated.

Discussion in 'Automobilista 2 - Help & Support' started by Newbie, Jan 17, 2026 at 7:37 PM.

  1. Newbie

    Newbie New Member

    Joined:
    Jan 9, 2026
    Messages:
    2
    Likes Received:
    0
    I have tried using the Logitech Pro setting, but it will not register any degrees of input during calibration. If I bind the controls and try to drive, either the wheel gets stuck in the full right or left position. I tried calibrating with the wheels degrees set at 180, 240, and 1080. Same results. Tried setting it up with the generic (Custom) setting, but it shows rotation degrees during calibration after binding the controls. But when I try to drive, the wheel vibrates so wildly that it feels like it is going to rip itself from its mounts. My wheel settings are set at Pro, FF Filter 1, Damper "Off", TF 40, Angle should remain set at 1080 if I can get it calibrated. This is my last hope before I uninstall the game permanently.
     
    Newbie, Jan 17, 2026 at 7:37 PM
    #1
  2. Marius H

    Marius H Forum moderator Staff Member AMS2 Club Member

    Joined:
    Mar 24, 2016
    Messages:
    6,947
    Likes Received:
    3,742
    Hi,

    Welcome to our forum. Sorry to read that you're experiencing problems. So to my understanding, you've tried the Custom mode. Have you also tried the Generic mode or the Legacy mode? I don’t own a Logitech wheel, but for some people, those modes seem to help. Select one of the modes, bind your wheel and peripherals, and go on track.

    Also, make sure you set the gain to a correct level. The wild vibration of the wheel is likely because the gain is set too high.

    If possible, can you make a video of your issue? How you set up your wheel, settings, etc. That would help clarify the problem further.

    Please don’t hesitate to leave a reply if you need further help.

    Marius
     
    Marius H, Jan 18, 2026 at 12:07 AM
    #2

Share This Page