I switched to a Moza R9 and can't get it to calibrate. I've tried all wheel options (ie Custom, Generic Direct Drive etc) and when I try to Edit Assignment it won't register a left or right turn on the wheel. Is there a workaround to this because right now I can't get the thing to work?
I use legacy DD you have to edit steering inputs turn all the way to the left then back to centre same for right
I use an R12, as Custom IIRC. My suggested process: Set the max steering angle as low as possible in Pit House. Launch AMS2. Bind the steering - you need to bind both left and right. This step is why the low steering angle, it's because the game expects to see a big change in the value of an axis on a controller, and the low steering angle makes this much easier. Save and quit AMS2. Set the steering angle back to your preference - for AMS2 I have it set at 2700, the maximum. Launch AMS2 again. Go into the steering calibration area. When prompted, steer all the way to max lock in either direction, then click the next button. It will prompt you to turn the wheel 90 degrees. What it means is return the wheel to centre, and then turn 90 degrees from centre. When you do this you should see the number on screen match (or be very close to) your chosen max angle in Pit House. Then you're done (bind the buttons etc of course). In the car the game should adjust the max steering angle to suit the car, and you should see that the on screen steering wheel matches the movement of your wheel. If not, make sure that steering sensitivity is set to 50 (the default), as that is linear.
