Hello, I saw 1.5.5.0 came out, and I noticed that there are still cars with camera clipping issues in hood/bonnet camera view. I then went and collected all the cars that I believe have clipping issues (I'm hoping I didn't miss any, there are a lot to go through). Copa Fusca This one clips through and you can see the ground. Formula Inter MG-15 The engine is visible while driving as the car shakes. Formula Reiza This clips and you can see through to the ground. Formula HiTech Gen1 Model2 As the antenna moves around, it clips into the camera. Formula HiTech Gen2 Model2 Same as above - as the antenna moves around, it clips into the camera. As I finished collecting the list, I started to adjust the options in the hood/bonnet camera to see if I could try to resolve this on my own. I noticed that all of these appear to get fixed once I default the FOV down to 80 (which I think is the default). I would like to be able to run a higher FOV, and these cars are the only ones that don't like a 90+ FOV. Most of them likely would be fine if I could adjust my view up one or two (with the WASD keys) so that I can no longer see through the hood. So my question is this - What is the FOV range I should expect to be able to run without running into clipping issues with the hood/bonnet camera? I can clearly resolve this on my own by dialing it down to 80, but I also sit just close enough to the TV that the default FOV is too narrow and setting it too high causes these issues (I was running 95). Screenshots in case it helps -
