Hello, I've just discovered that Part Pedal Press, maybe 30%, gives me full throttle, I always presumed it was the physics model/Madness Engine that was producing random spins when applying part throttle, say exiting a corner, but all along I was unknowingly applying full throttle. Is there something in AMS2 controller configuration page I can Adjust to correct this Pedal behaviour? Pedals used: Heusinkveld Sprint connected direct to PC, Calibrated first with Smart Control, then in AMS2. Thankyou for reading. J
Hey, 30% of pedal travel are showing as a fully filled green bar in the telemetry HUD? Does your Pedals software also show 100% at 30% pedal travel already? Pedal Calibration faulty for some reason? -> Calibrate your pedals in the controls settings of AMS2, while being in a race session for a test. Have you checked your deadzone settings? Sensitivity 50 is linear, not 100. Does the RPM leap upwards very sensitive and fast, even at just 30% of pedal travel? (but also shown as about 30% travel and not 100 in the green throttle bar in Telemetry HUD?) -> Throttle to RPM sensitivity will receive some tweaks soon, so just a matter of waiting a bit, for now a workaround might be to lower throttle pedal sensitivity in the controls menu until the updated throttle behaviour drops.^^
Hi CrimsonEminence, Thankyou for responding, You were spot on with the Deadzone sensitivity being at 100, not at 50 as you suggested. This has made the pedal Perfect, and as a result, posted my fastest Lap on Imola Historic 1972. Thankyou Jason