Automobilista 2 Custom Force Feedback - Overview & Recommendations

I've spent a few hours with your latest file and ended up with this.
I changed the dt value as well as other things including tyre resistance values.
feels really nice on my csw, it's a keeper for me.
Hope you don't mind me putting it here.

 

Hi buddy! No problem my files are for everyone, there are no secrets. Yes, I have seen that you have adjusted a few values to your base. Flat spot do you consciously set to 0.01?

 

You hidden the dt value? As far as I know, this value should remain. I activated it a long time ago, has there been a change? Will test it tomorrow and let you know Alex

 

Thanks to all involved for this , really appreciate the effort and knowledge that goes into these files .
I use a Simplicity 20 nm direct drive wheel base and am still searching for the perfect feeling . For me Daniel's last few files would be perfect apart from lacking any feeling of grip loss when the tires break traction . At the moment the weight of the wheel doesn't decrease under lock up during braking or understeer through a corner or even on grass when you would expect less friction between the tyres and the surface. Could this be simulated ?

 

It's also a matter of taste, I don't like it too easy because it takes control of the car away from me. But yes, you can increase (slide_factor 0.5) and adjust it to your liking

 

Not hidden, changed to 300 from 333. I might increase flatspots a bit more as it punishes me for poor brake control.

 

I can feel it, have you got too much damping applied maybe?

 

Will have a look thanks .

 

I'm only on the phone, but you hidden dt with # maybe I don't see everything on the phone? Good night

 

Didn't notice that, well spotted!
I'm surprised it feels so good without it tbh, think I'll leave it off.

 

This one is similar to Daniel's but with the grip loss feeling.

 

Thought it was my old one I quickly tested Alex for "dt" before work. I have the advantage that I can also simulate your power. With 5-6Nm it is only slightly felt. But the higher the power, the worse it gets. There are vibrations in the steering axle and the wheel starts to swing. It feels like the steering axle is jumping, that's wrong information coming to the wheel. But like I said, with less power it's less noticeable or not at all and if you feel better that way then it's okay. You should always listen to your own feelings and then it will be fine

 

Yes I agree it's

Thanks Theodore, will have a go next time I'm on .

 

Hi guys! Due to the very good hint from Alegunner68, there are new customs. I can maybe post 3 new V47 files over the weekend, all based on the V46 but with some modifications. All 3 files are now even more power based. The 1st file will be specific for dd bases with high forces (tested with 12-13Nm peaks). The 2 file will be for bases up to about 6Nm peaks (tested with 6Nm peaks). The 3 file will again be an attenuated file for dds 12-13Nm peaks (motion-tactile file). I will test a little more before I post everything. In any case, the feeling after my first tests is fantastic. See you Daniel

 

What would you recommend for Csl DD 8nm , Base and ingame Settings ? For base I use the recommend settings from Reiza

 

Hello Morek! 10 people will recommend 10 different settings to you. You can find my recommendation in my file. Test different settings and above all my recommendation is: In the end, always take what you like and where you feel best

 

Hi there where I can find the latest custom file Danielkart?

 

Hi Markus! On page 300 in this thread

 

Hi which one works best with simucube 2 pro?

 

V46 or V46 Motion Tactile file.