Bug Reports - Automobilista 2 (Read the Opening Post)

Ginetta P1 does not have Rear Wet tires
Version: 1.48 RC
Track: Spa Francorchamps
Applicable Setting: Tires
Report: The Ginetta P1 does not allow wet tires on the rear.
They cannot be manual selected (Only Soft Slick and Applicable by weather)
If you select Applicable by weather you only get soft slicks no matter if track is wet or dry
Front tires can be changed to wet or dry.

 

Version: 1.4.8 2299 RC
Track & Layout Used: Barcelona
Car Used: Formula USA 2023
Applicable Settings: MP session
Q 10mins (private session On)
R 20mins + 1 lap
Visual Damage Only
forced default setup
Mandatory pit stop: on
Mandatory change tires : 4
Racers : 9 racers
Report: random users (3 or 4) got DQ on last lap even they successfully did mandatory pit stop and mandatory tires changes.
Steps to reproduce: MP with settings above.

 

Version: 1.4.8 2299 RC
Track & Layout Used: Barcelona
Car Used: Formula USA 2023
Applicable Settings: MP session
Q 10mins (private session On)
R 20mins + 1 lap
Visual Damage Only
forced default setup
Mandatory pit stop: on
Mandatory change tires : 4
Racers : 9 racers
Report: In qualify with private Session,
There are Whoosh sounds and crew chief warns nearby approaching.
Steps to reproduce: MP with settings above.

 

Version: 1.4.8 2299 RC
Track & Layout Used: Any
Car Used: Formula Classic Gen2
Applicable Settings: Single Race
Formula Classic Gen2
Opponent Max available (27)
Report: 2 low Down force versions in grid
Steps to reproduce: refer above

 

Version: v1.4.7.2
Track & Layout Used: Jerez Historic 1988
Car Used: All
Applicable Settings: I only have VR(tested two headsets, Reverb G2 and Pimax Crystal) so I don't know if it also happens without VR but I think it does/probably does
Report: ALL 3D people models that stand on the side of the road at rougly 100-200? meters and above are not there.

Level of detail should be further away, it should be ~500 meters but that's not even the biggest issue:

The biggest issue is when you get closer then that then there is a HALF BODY(head is cut off the body) person standing there. When you drive even closer (VERY close) at around a ~75 meters, THEN the head comes on the body and the 3d people model gets complete.

This completely ruins the immersion in this track for me. I hope that it can be fixed because it's an amazing looking and driving track. Thank you for your attention.

Steps to reproduce: Drive on Jerez Historic 1988 and you will see the strange half body 3d persons with cut off heads on the side of the road...

 

Version: 1.4.8 2299 RC
Track & Layout Used: Laguna Seca
Car Used: Formula USA 2023
Applicable Settings: Any time you drive, default car setups and with some adjustments too.
Report: The curbs in the exit of turn 10 (the one that kind of points toward the pit-entry). If you run the left side tyres a bit over, the car comes to an almost immediate stop. So lets say when the car should behave like a bottom-out, it just behaves real weird. Had similar happen when going over the exit curbs in turn 9 aswell but I can't confirm that it's consistent as I rarely go out there.

Going off the wiki map for turn numbering: https://upload.wikimedia.org/wikipedia/commons/5/57/Laguna_Seca.svg

 

Version: 1.4.8 2299 RC
Track & Layout Used: any
Car Used: Formula Junior
Applicable Settings: Steam VR
Report: The Formula Junior mirrors do not change perspective, when you move your head in VR. The reflection in them stays fixed.

This feature works correctly for the new F-USA 2023 and F Inter.

 

It works. You've got to hold "boost" button down and it very slowly depletes the blue icon in the HUD.

 

Version: 1.4.8 2300 RC
Track & Layout Used: Barcelona
Car Used: Formula Junior
Applicable Settings: test day
Report: car sound strange by angles
Steps to reproduce: refer video

 

Version: All (maybe)
Track & Layout Used: All
Car Used: All
Applicable Settings: All cases where the initial tire temperature state is blue (perhaps the same applies to the green one)
Report: On the telemetry HUD page, the tire temperature color in the lower right corner will not automatically change. If you switch HUD and return to the telemetry HUD page, the color will remain in that instant state.
Perhaps the same goes for green, but I have never encountered a situation where green changes to another color, so I cannot determine whether the color in the lower right corner has been changing or not.

 

The UI shows the same amount of turns for both layouts of the Barcelona track, which i think is incorrect, it shows 16 turns for both, whilst the layout without the chicane has 14 turns.

 

The Indianapolis Oval track is no longer lit. I would swear she was before. Anyone else notice this?

 

Version: 1.4.8 2302 RC
Track & Layout Used: Nordschleife 1971 Gesamtstrecke
Car Used: Formula Retro Gen1
Applicable Settings: Single Event AI 90
Report: AI colliding with invisible obstacle in compression end of Fuchsröhre, has happend more than once
Edit: also lots of driving mistakes by AI
approache

ready for lift off

lift off

landing and standing still for a second

bouncing again

causing mayham

 

This was in the RELEASE CANDIDATE. And now it's still exactly the same in the Final.

I hope that this will be hotfixed, since the amazing new car is now not usable in VR.

How can this this be overlooked by dev's? Do they not have a VR hmd?

The mirrors can:
1. not be adjusted
2. don't move when you move your head.

 

Holy crap!! Wasn't that issue one of the improvements that are gonna be fixed in 1.5?
The sudden bottom out of cars on some parts of some circuits, happens sometimes in Hockenheim historic in the Vintage-G1 just after the first right hander, you hear a BANG and a sudden compression.

Think it was supposed to be an issue with the undertray and suspension.

 

Track & Layout Used: Monza Historic 10k (seems to happen in any track)
Car Used: Formula Junior
Applicable Settings: Weather - Sunny (other settings seems irrelevant)
Report: no tire or road surface sound when racing against AI after a few minutes

Would love to race the Formula Junior, but no tire sounds is quite distracting

 

Version: 1.48
Track & Layout Used: N/A
Car Used: N/A
Applicable Settings: N/A
Report: Server lobby: RCO.R.6437 racecraft.online Race server is visible WITHOUT a password in the server list(no lock). But when I try to join it, it gives an error that I cannot join it because I don't have the password. It's been there for days/a week or something and it never works.
Steps to reproduce: go to Multiplayer server list

 

I think that server uses a whitelist, which means you can only access it if your steamid is on the whitelist, i dont think this is an ams2 issue, but RCO related

 

Thanks.. I didn't know that this was possible. I hope that it can be disabled with the next release, this possibilty, just to keep the server browser clear for everyone. Just a password should be sufficient for private servers. Now it's unclear what server is accessible or not.

 

Having been racing the ginetta G58 the last few nights in a custom championship and the new physics really shine through, amazing car to drive now.

I think I have found an issue with the new tyre pitstop thingo though. I must have had the mandatory tyre change set to 0 and in two races now I have set my pit strategy to change all tyres and when pitting the pit crew are changing them but the tyre widget shows the tyres as not changed as when I drive out of the pits they still have the wear on them, this has happened with multiple pitstops in the two races.

The races were imola and Watkins Glen short 30 minute races real weather, x4 fuel and tyre wear, x5 weather