Bug Reports - Automobilista 2 (Read the Opening Post)

Track & Layout Used: Cascavel
Car Used: GT5 Ginetta G40, not replicable in Formula Trainer so feels fairly isolated
Applicable Settings: Weather - any (tested with Heavy Rain and Dry)
Report: The tarmac (concrete) track surface between last corner and start line have a rumble strip effect attached that triggers the FFB and associated sound effect. I thought initially it was something to do with the rumble effect not clearing after going off the kerbs but it was the same even without going too wide but near the kerb too.
Steps to reproduce: Drive the Ginetta G40 GT5 car on Cascavel and the concrete (lighter texture) strip before start/finish line activates the rumble strip FFB and sound.

 

Version: V1.6.9.96
Track & Layout Used: N/A
Car Used: N/A
Applicable Settings: Traction control
Report: onboard traction control setting increase/decrease. in AMS2 settings now always shows as NONE.. but the button u tried to assign actually works when on track. needs fixing!

 

Version: V1.6.9.96
Track & Layout Used: N/A
Car Used: F1 V8 Gen1 - Renault - likely applicable for the other cars too

You can go as low as 1.30 bars on the rear tyre pressures in the setup but in the strategy menu it caps out at 1.39/1.4 bars
Update: It appears that it is actually an other issue linked with some online server shenenigans, on another server it worked fine as it should.
No idea how the server could impact tyre pressures solely in the strategy box but hey, here we are ^^

 

Version: V1.6.9.96
Track & Layout Used: Barcelona
Car Used: N/A
Applicable Settings: Non-driver specific
Report: Driver names are missing from the display board at the entrance to the Barcelona circuit.

 

Version: V1.6.9.96
Track & Layout Used: Any
Car Used: Any
Applicable Settings: Any
Report: Whenever I connect to a multiplayer lobby, all the race settings for that lobby are applied to my lobby when I want to create one.
Steps to reproduce: Connect to any lobby in the multiplayer section. Leave that lobby. Create a new lobby. The settings from the lobby you previously joined will be applied.

This is annoying because all lobbies have different settings and I have to run through all of them and change them when I want to create my own lobby

 

Version: V1.6.9.96
Track & Layout Used: Imola historic 2001 (But the same happens in Suzuka)
Car Used: Formula V10 Gen 2.
Applicable Settings: Clear weather
Report:The engine takes 1% damage with clockwork precision every one and a half laps. This means that in a 60-lap race, the engine wear is around 40%. Above 25%, the warning indicator turns orange, and there is a high risk of not being able to finish the race.

It happens with the default setup too, but I've tried the followings:

• Opening up the radiator/engine cooling
• Softening the suspension
• Raising the ride height
• Change gear carefully

With some setup tweaks, I might have improved the engine wear by a tiny bit, but not by much. I think this might be a bug.

Steps to reproduce:
Select the car and the circuit, put 10 laps of fuel (use the default setup) and doing some laps.

 

Version 1.6.9.96.3436
Track & Layout Used: Adelaide '88
Car Used: Any
Applicable Settings: Drying circuit
Report:
Full details for race here

Code:

https://youtu.be/Wyfo0clZlCQ?t=6459

On a drying circuit, on the entrance and exit of the last corner, the circuit off the racing line has dried, while the racing line has remained wet, the inverse of what you'd expect to see.

Code:

https://youtu.be/Wyfo0clZlCQ?t=9247

All the best
Andy

 

Version 1.6.9.96
Track & Layout Used: Any
Car Used: Lister Storm GTM
Applicable Settings: Any
Report: The suspension seems to be bugged, no matter the settings there is very little travel while standing as well as driving as seen in the attached screenshots. Hopefully fixing this will help its performance in the class a bit as well as it is pretty slow there.

 

Version: V1.6.9.96
Track & Layout Used: Campo Grande
Car Used: Ginetta G40 Cup
Applicable Settings: Multiplayer, 30 minute race night race, authentic settings, vehicle reset ON.
Report: It seems like when a user retires to the pits mid race, their car flickers on track. It's like the car is on track but not. While the car isn't actually there and is basically a ghost, it takes away from the realism to see the retired car of a competitor flicker on track at multiple locations. I know this is a long standing bug that exists in the game during night races. We've also seen this happen at Tarauma and a few other tracks that I can't remember off the top of my head.

 

Version: V1.6.9.96.3436
Track & Layout Used: Donnington National
Car Used: Caterham Academy
Applicable Settings: Multiplayer, 30 minute race, authentic settings,.
Report; With display set to Imperial un its the setup shows psi but the pit strategy shows bar

**** for some reason i cannot attach file to the post ?

 

Version: 1.6.9.91
Track & Layout Used: N/A
Car Used: Various Cars
Applicable Settings:
I've had that on many tracks with various cars

 

Version: V1.6.9.96
Track & Layout Used: Any
Car Used: Any
Applicable Settings: Any
Report: Yesterday, the players' rankings were reset, and their progress in the multiplayer sections was blocked. The report about previous races on the profile screen showed the safety ranking at the minimum. Creating new race servers also didn't allow setting a minimum rank to enter, limiting it to U0. Today, the situation was the same, but after entering the Multiplayer screens, the ranking shown at the top of the screen changed to the correct number, and the profile screen was restored.

 

Version: V1.6.9.9
Track & Layout Used: Hungaroring (Multiplayer)
Car Used: Lola B05/40 Turbo
Applicable Settings: Weather - Clear (moist)
Report: I got the out of body camera as used to happen when viewing other player's cameras at the session changeover from quali to race when using free look in the monitor
Steps to reproduce: Go to monitor, press ctrl+F, stay in free look until the session ends. Race starts with view in the garage

 

Version: V1.6.9.9
Track & Layout Used: Any
Car Used: Formula Edge Model 1
Report: Side mirrors - vertical tilt doesnt work

I wonder if the devs look at these bug reports.....

 

Thank you

 

Version: V1.6.9.9
Track & Layout Used: jerez moto TT
Car Used: Maserati MC12
Report: possible to load TT setup from Lambo GT1 2005 into MC12

I can load the setup from another car and i see changed values. This should not be possible at all.

... and plz fix the MC mirrors

 

Version: V1.6.9.96

Bug 1 : single race
Applicable Settings: Single Race with 2 classes (in this example LMDh / GT3)
Report: Stock Car 2024 is default player vehicle every time you re-enter single race.
Steps to reproduce: Create a single race with classes LMDh and GT3. Select an LMDh or GT3 vehicle. Go back to main menu, create a single race again. The Stock Car 2024 is again chosen vehicle and inserted as a class in the opponents section.

Bug 2 : single race
Applicable Settings: Single race with 4 weather slots in all sessions (P/Q/R)
Report: Slot 3 and 4 of qualifying displays the weather slots 3 and 4 of the race
Steps to reproduce: Create a single race with all 4 weather slots set to clear. Change weather slot 3 and 4 of the race to random and see the icons of qualifying weather slot 3 and 4 change as well.

(In multiplayer this displays correctly)

Bug 3: weather and time progression
Applicable Settings: Le Mans dedicated server with starting dry conditions, rain after a couple of minutes.
Report: As soon as the light rain slot kicks in, the track goes from dry to soaked in a crazy short period of time (in a GT3 car, coming onto the Mulsanne straight it goes from dry to moist, before the end of the Mulsanne straight the track is soaked)
Steps to reproduce: slot 1 light cloud, slot 2 light rain, time and weather progression x30.

Wet weather with high progression is unusable with high time progression. I'd love to have the option to let for example 6 or 8 weather slots pass (with some randoms in between) with day and night cycle by experimenting with these settings. The slots should pass quicker, but the amount of rain, thus wetness on track seems to also increase with this number. I think that's not how it should work. But love to hear your thoughts on this.

Bug 4: flasher headlights are not visible to other players in a multi-player race, only in single race

Applicable Settings: Any lobby with GT3 or LMDh cars, and probably other cars as well.
Report: No flasher visible to other cars
Steps to reproduce: Connect 2 players to the same lobby, select a vehicle with flashing headlights options. Flash headlights near the other connected driver, no flasher visible for the other driver. The normal headlights on/off are working perfectly.