Issue with Fanatec Clubsport Wheel base V 2.5 / Clubsport Pedals V3

Hi guys,

I can see my wheel and pedals in AMS2, however I can't assign/edit any inputs as both the wheel and the pedals are not recognised.

It worked once, but following the an update it stopped working.

Any clues on how to solve that problem?

It's frustrating as I backed the game, but did only manage to play only 1 hour in total... just because it doesn't work.

Thanks for your help

 

I don't own a Fanatec wheel, but maybe you could try this.

edit : here is another one you could try.

 

Thank you.
I will try the second tip tonight. I had already tried to use "Custom Wheel" settings, but I could not assign inputs to steer left and right, or for the pedals.

 

I’ve tried both solutions today and it doesn’t work.
Either way the wheel and the pedals are not recognised and I can’t edit the assignments.

Isn’t it ironic when you look at the game’s load screen???

 

Hello,

Any ideas on how to solve this issue?
I can't get my wheel and my pedals to be recognised.

Thanks

 

Not sure if this is helping (as you seem to have a different issue than me) but I just had problems calibrating the V3 pedals. Turns out I first had to assign controls to them and then I could calibrate them.

 

Hey,

Bumping up this thread.
Few months in, and I still can't play AMS2 because the game does not recognize my wheel and my pedals. I've tried to set it up as a custom wheel, same issues.
It's the only sim that does not recognise my wheel and pedals even when I select the right profile in the control settings.

Any idea as I even uninstalled the game, and started from a clean setup.

Thanks

 

Just to confirm - you say you can't edit assignments for the wheel axis? Remember, you have to rotate it fully before the game picks up the input when doing this!

For the pedals - do you have them plugged into the wheel base or via USB?

Also, what Fanatec drivers/firmware are you running?

 

Damon, has your wheelbase and pedals never been recognized in AMS2, or was it recognized before and is now no longer working?

EDIT: I read your post again, and you said it worked before. Follow the advice of CrimsonEminence above, is what I can say.

CSW2.5 & CSP V3 inverted user here, by the way. I've earlier had some issues getting my McLaren GT3 (mk1) wheel rim to be recognized in a few arbitrary sims. I can't remember if AMS2 was one of them, but since I got drivers after v378b IIRC, I have not had any trouble except in AMS1 where the MPS switches require me to use my CSL Elite wheel rim instead. I once had a driver conflict where no sims were recognizing my wheelbase, rim and pedals, and then I had to completely uninstall the Fanatec driver and then re-install it. But I don't think that is necessary for you to try, since it's working for you in other sims.

What wheel rim are you using?